Star Wars Rogue One Shore Trooper Helmet (3d printed)

I 3D printed a Shore Trooper helmet from Star Wars Rogue One! Check out how I did it! TOOLS LIST: (some are better than the versions I own) http://amzn.to/2akFubx - Orbital Sander http://amzn.to/2ay8ICl - Dremel tool http://amzn.to/2ay9XRX - CA Glue (medium) http://amzn.to/2ay9T4v - CA Activator http://amzn.to/2hrl6Wj - Air brush with compressor (mine is Harbor Freight) http://amzn.to/2hnwja9 - Bondo glazing putty (good for small spots & seams) http://amzn.to/2hmAtlz - Bondo body filler http://amzn.to/2hnv4Yt - Bondo spreaders http://amzn.to/2hrfrj0 - 3M Flexible sand paper (150 grit) http://amzn.to/2hnBiaM - 3M Flexible sanding sponge (220 grit) http://amzn.to/2hKh765 - Pin stripe masking tape (0.25") http://amzn.to/2axPtbL - Silhouette Portrait (vinyl cutter) https://www.matterhackers.com/store/printer-k… - Ultimaker 2 Extended 3D printer https://www.matterhackers.com/store/printer-a…