Shapeoko 3: My First Cuts & Project

Winston Moy6:042015DIY & Crafts

An introduction to the Shapeoko 3 (2015), the state of software support, and my first project utilizing the S3's larger work area (a DIY vacuum table). Note: The information given in this video is an extrapolation from my cursory research on the subject. It may not be 100% accurate, nor current. Get Carbide Motion here: http://carbide3d.com/downloads/ Get Universal Gcode Sender here: https://github.com/winder/Universal-G-Code-Se… My threaded inserts: http://amzn.to/1bbeWi9 NOTE: DO NOT use the 9mm hole diameter indicated on the packaging. I've found 8mm (5/16") to be a much better fit. Keep this in mind if you're programming your own holes, or drilling them by hand. ----- Outro: "Extreme Sport" by K-319

Landed here from a link? Roll your own.

🎲 Roll the Dice

Played through the official embedded player. Watch on YouTube.