Building a Tablesaw Outfeed Table | Easy to Build | WOOD Magazine

WOOD magazine16:572022DIY & Crafts

For safety and cut quality, workpieces should be well-supported as you feed them off a tablesaw. Jim walks you through building an outfeed table that provides ample support even for full sheets of plywood. A flip-up wing provides massive surface when needed, then folds down to a compact footprint. And for ultimate versatility, casters allow you to roll it out of the way. It even gives you pass-through storage for cut-offs or clamps. 00:00 Introduction 01:15 Build the Base 03:25 Construct the Case 06:56 Add a Wing 13:00 Building the Top 14:12 Attaching the Top Purchase complete plans with measurements and drawings at https://woodm.ag/tablesawoutfeed Purchase the casters Jim used at https://woodm.ag/4inchcasters Purchase the leg bracket hinges Jim used at https://woodm.ag/legbrackets WOOD may receive a small affiliate fee with your purchase. Subscribe to the WOOD YouTube channel: https://www.youtube.com/subscription_center?a… Subscribe to WOOD magazine: https://www.woodma

Landed here from a link? Roll your own.

🎲 Roll the Dice

Played through the official embedded player. Watch on YouTube.