Framing A Support Wall Under Stairs
HAUS PLANS ®️1:002024DIY & Crafts
These stairs have a lot of bounce to them, I’m going to frame a support wall in the middle to fix it. First, I measure and lay off where the wall will go. Then I cut a pressure treated 2x4 to the width of the stairs- 42”. I fasten it to the floor using three masonry screws. Next, I use my 4-foot level to plumb up and mark where the top of the wall will meet the stairs. I make a mark on both ends and connect them with a level. Now I need to figure out the angle of the steps- I start by making a plumb line on the stringer; then I take my speed square and rotate it so it’s parallel with this line- It’s a 31-degree angle. I used my table saw to make a 31-degree bevel on both sides of the top plate. I fasten this to the bottom of the stairs using decks screws- two per stringer. Measuring from the bottom plate to the top plate I get the lengths for my studs. I set my miter saw to 31-degrees and make the cuts. It’s good to check that the angle is correct before cutting all of them. I use sc
Landed here from a link? Roll your own.
🎲 Roll the DicePlayed through the official embedded player. Watch on YouTube.