Improvised 3D printing support for a moose

Richard Gain3:242012Bricolage

I wanted to print this great little moose http://www.thingiverse.com/thing:24393 but my favourite slicing software, slic3r, isn't so great at generating support material. It got the neck, belly and antlers right but completely missed the muzzle. Half way into the print I suddenly realised it woul be ruined if I didn't work out a way to catch the extruded plastic on some sort of improvised platform. I looked in the printing software and saw that the muzzle started at layer 143. I was printing layers 0.2 mm thick so the platform needed to be 143 x 0.2 = 28.6 mm tall. I set my digital caliper to 28.6 mm and used it to scratch two lines across the ends of a business card and then folded the ends to 90 degrees. I taped the card to the platform when it reached layer 140. The first layer of plastic failed to stick to the card so I quickly added a piece of Kapton (polyimide) tape and the next layer stuck firmly allowing the rest of the model to complete without incident. Printed on the eMaker

Chegaste aqui por um link? Lança tu também.

🎲 Lançar os Dados

Reproduzido pelo leitor oficial incorporado. Ver no YouTube.